| <<Previous | Index | Next >> | ||
 |
 |
 |
 |
|
The wiper and shaft are from 2mm stainless steel rod. It is about 0.6gr heavier than the 1.5mm wiper + carbon shaft that Mark shows on the plans. I might shorten the shaft and use 2.6mm O.D / 2.1mm I.D. syringe needle for the most part of the shaft. The pocket is almost per plans. I used matches for pocket walls. Important: make sure that the wiper is not too long. I made this error and wiper touched the back of the pocket and was pushed into the wing.
Created with Web Album Generator